XQ-2B Metallographic/petrographic Samples Mounting Machine Product Introduction This machine is used for inlaying small, difficult to handle or irregular metallographic and petrographic samples before grinding and polishing. After mounting, it is convenient to polish and polish the sample. At the same time, it is also helpful for the sample to observe the material structure under the metallographic microscope; test the hardness of the sample on the hardness tester. The mounting machine can work reliably under the following conditions: 1. The altitude is not higher than 1000m. 2. The temperature of the surrounding medium is not higher than +40ºC and not lower than -10ºC. 3. The relative humidity of the air is not more than 85% (at 20°C). 4. There is no conductive dust, explosive gas, or corrosive gas that can seriously damage metals and insulators. 5. There are no obvious vibrations and bumps.
Technical specifications Sample pressing diameter: Φ22, Φ30, Φ45mm three specifications (one standard configuration, select when ordering) Temperature control range: 0-300ºC Net weight: 33kg Timing range: 0-30min Heater: AC 220V/50Hz/400W Dimensions: 400mm×290mm×400mm
Standard configuration of accessory box: Host: 1 Power cord: 1 Inlay material: 1 pack (500g) Technical documents: 1 copy each of manual, certificate, and warranty card
Audited Supplier 
){kind=link}